|
Wavetek Meterman LP10A Logic Probe
Click image to enlarge
Wavetek Meterman LP10A
|
|
Features:
- Pen-sized logic probes
- Troubleshoot and analyze digital logic circuits
- Powered by circuit under test
- Detects pulses>30 ns up to17 MHz, TTL, CMOS levels
- Dual LEDs indicate hi/lo state
- Pulse memory indicates single occurring pulses
|
Description
The LP series of logic probes troubleshoot
and analyze most digital logical circuits.
The LP10A logic probe is used for most types of TTL and CMOS circuits.
This logic probe detects pulses of more than 30 ns up to 17 MHz.
|
Models, Options, & Accessories
| Model |
Description |
List Price |
Sale Price |
| LP10A |
Logic Probe, 17Mhz - Discontinued - suggested replacement: Amprobe LP10B |
Specifications
| TTL/CMOS Selectable |
Yes |
| Signal |
Requirements
|
Logic “1”
Logic “0” |
| Maximum Input Signal Frequency |
20 MHz |
| Minimum Detectable Pulse Width
@ + 3 V |
Frequency
|
< 1 kHz
1 kHz–20 kHz
20 kHz–20 MHz |
| Input Impedance |
1 MΩ |
| Pulse Indicator Flash Time |
500 mS |
| Audible Tone at Pulse Rate |
No |
| Pulse/Memory |
Pulse uses the pulse detection
modes listed above. Memory allows the probe to capture a positive
or negative pulse greater than 30 nS in width. The yellow LED will
come on and stay ON until switch is reset to PULSE. |
| Power Requirements (from circuit
under test) |
LP10A |
| Power Supply |
5 - 15 V DC |
Power Supply Current
|
@ 5 V 30 mA
@ 15 V 80 mA |
| Power Supply Protection |
20 V AC/V DC |
| Maximum Input Voltage (15 seconds) |
40 V AC/V DC |
General Specifications
| Use |
Indoor |
| Operating Temperature |
0 °C to 50 °C at 80 % R.H. |
| Storage Temperature |
- 20 °C to 65 °C at 75 % R.H |
| Dimensions |
210 mm x 18 mm x 18 mm (8.2" x 0.7"
x 0.7") |
| Weight |
38.1 g (1.3 oz.) 42.6 g (1.5 oz.) |
|
;)
