| Specifications |
| Maximum sample rate |
10MHz for repetitive signals (2MHz for single shot events) |
| Maximum input amplifier bandwidth |
2MHz ( -3dB at 50mV, 1V & 20V /div x1 setting) |
| Input impedance |
1Mohm // 20pF (standard oscilloscope probe) |
| Maximum input voltage |
100Vpeak (AC + DC), 200Vpeak-peak (AC only) |
| Input coupling |
DC, AC and GND (GND for auto zero reference) |
| Vertical resolution |
8 bit ± 1bit linearity |
| Trigger modes |
Run, Normal, Once, Roll mode for 1s/div and slower timebase |
| LCD Graphics |
64 x 128 pixels |
| Signal storage |
256 samples with 2 memories, max. 125 samples visible (256 using X shift) |
| dBm measurement |
(0dBm= 0.775V in 600Ω) From -73dB tot +40dB (up to 60dB with X10 probe) ±0.5dB accuracy |
| dBV measurements |
(0dBV= 1V) From -75dB tot +38dB (up to 58dB with X10 probe) ±0.5dB accuracy |
| True-rms measurement |
From 0.1mV to 80V (up to 400Vrms with X10 probe) 2.5% accuracy |
| Peak to peak AC range (sinewave reference) |
0.1mV to 160V (1mV to 1200V with x10 probe) 2% accuracy |
| Timebase range in 32 steps |
0.2µs to 1hour / division |
| Input sensitivity range in 12 steps |
5mV to 20V/division at X1 - 50mV to 200V/div at X10 |
| Probe calibration output |
Approx. 2,5KHz / 5Vpp |
| Supply voltage |
9VDC/ min 300mA adapter (unregulated) 12VDC if regulated Batteries (option): Alkaline type AAA or Ni Cd / NiMH rechargeable ( 5 pcs required) |
| Charge current for rechargeable batteries |
90mA |
| Battery life |
Up to 10h with Alkaline batteries (OFF or standby current < 100µA) |
| Operating temperature |
0 to 50°C (32 to 122°F) |
| Physical characteristics |
Dim- 155x100x45mm (6,2 x 4 x 1,8”) Weight 395g (14oz.) ex. Batteries |
| RS232 output |
Galvanic isolated RS232 output for PC |
;)
;)
;)
;)
;)
