| Specifications |
| Maximum sample rate |
40MS/s for repetitive signals (10MS/s for single shot events) |
| Input amplifier bandwidth |
(-3dB) From 5MHz at 5mV/div to 12MHz at 50mV, 1V & 20V /div |
| Input impedance |
1Mohm // 20pF (standard oscilloscope probe) |
| Maximum input voltage |
100Vpeak (AC + DC), 200Vpeak-peak (AC only) |
| Input coupling |
DC, AC and GND (GND for auto zero reference) |
| Vertical resolution |
8 bit + 1bit linearity |
| Trigger modes |
Run, Normal, Once, Roll mode for 1s/div and slower timebase |
| Trigger level |
Adjustable in 8 steps |
| LCD Graphics |
112 x 192 pixels with LED backlight |
| Signal storage |
256 samples with 2 memories, max. 179 samples visible (256 using X shift) |
| dBm measurement |
(0dBm= 0.775V in 600ohm) From -73dB tot +40dB (up to 60dB with X10 probe) +0.5dB accuracy |
| dBV measurements |
(0dBV= 1V) From -75dB tot +38dB (up to 58dB with X10 probe) +0.5dB accuracy |
| True-rms measurement |
From 0.1mV to 80V (up to 400Vrms with X10 probe) 2.5% accuracy |
| Peak to peak AC sensitivity (sine wave ref.) |
0.1mV to 160V (1mV to 1000V with x10 probe) 2% accuracy |
| Timebase range in 32 steps |
50ns to 1hour / division |
| Input sensitivity range in 12 steps |
5mV to 20V/division at X1 - 50mV to 200V/div at X10 |
| Probe calibration output |
Approx. 2KHz / 4.5Vpp |
| Supply voltage |
9VDC/ min 300mA adapter (unregulated) 12VDC if regulated |
| Batteries (option) |
Alkaline type AA or Ni Cd / NiMH rechargeable (5 pcs required) |
| Charge current for rechargeable batteries |
90mA |
| Battery current (average) |
On: 170mA, with backlight: 240mA, standby current: < 600µA |
| Operating temperature |
0 to 50°C (32 to 122°F) |
| Physical characteristics |
Dim- 105x220x35mm (4.13x7.95x1.38”) Weight 450g (16oz.) ex.Batteries |
;)
;)
;)
;)
