| Specifications |
| Maximum sample rate | 10MHz for repetitive signals (2MHz for single shot events) |
| Maximum input amplifier bandwidth | 2MHz ( -3dB at 50mV, 1V & 20V /div x1 setting) |
| Input impedance | 1Mohm // 20pF (standard oscilloscope probe) |
| Maximum input voltage | 100Vpeak (AC + DC), 200Vpeak-peak (AC only) |
| Input coupling | DC, AC and GND (GND for auto zero reference) |
| Vertical resolution | 8 bit ? 1bit linearity |
| Trigger modes | Run, Normal, Once, Roll mode for 1s/div and slower timebase |
| LCD Graphics | 64 x 128 pixels |
| Signal storage | 256 samples with 2 memories, max. 125 samples visible (256 using X shift) |
| dBm measurement | (0dBm= 0.775V in 600ohm) From -73dB tot +40dB (up to 60dB with X10 probe) +0.5dB accuracy |
| dBV measurements | (0dBV= 1V) From -75dB tot +38dB (up to 58dB with X10 probe) +0.5dB accuracy |
| True-rms measurement | From 0.1mV to 80V (up to 400Vrms with X10 probe) 2.5% accuracy |
| Peak to peak AC range (sine wave reference) | 0.1mV to 160V (1mV to 1200V with x10 probe) 2% accuracy |
| Timebase range in 32 steps | 0.2µs to 1hour / division |
| Input sensitivity range in 12 steps | 5mV to 20V/division at X1 - 50mV to 200V/div at X10 |
| Probe calibration output | Approx. 2KHz / 5Vpp |
| Supply voltage | 9VDC/ min 300mA adapter (unregulated) 12VDC if regulated |
| Batteries (option) | Alkaline type AA or Ni Cd / NiMH rechargeable (5 pcs required) |
| Charge current for rechargeable batteries | 90mA |
| Battery life | Up to 20h with Alkaline batteries (OFF or standby current < 500µA) |
| Operating temperature | 0 to 50°C (32 to 122°F) |
| Physical characteristics | Dim- 105x220x35mm (4.13x7.95x1.38”) Weight 395g (14oz.) ex. Batteries |