| Frequency Characteristics |
| Frequency Range |
0.004Hz to 4MHz in 7 ranges |
| Ranges |
x1, x10x, x100, x1K, x10k, x100k, x1M |
| Dial Accuracy |
5% of full scale |
| Output Characteristics |
| Waveforms |
Sine, Square, Triangle, TTL Pulse |
| High Output |
Amplitude: 15mV to 10V (into 50W)
DC Offset: 0 to ±5 into 50W
Impedance: 50W
Attenuator: 30dB variable |
| Low Output |
Amplitude: 0 to 1V (into 50W)
DC Offset: 0 to ±0.5 (into 50W)
Impedance: 50W
Attenuator: 30dB variable |
| Sine Wave |
| Frequency Range |
0.004Hz to 4MHz |
| Flatness |
±2.0 % (0.004Hz to 400KHz)
±10% (400KHz to 4MHz) |
| Harmonic Distortion |
< 0.5 % on the 1K and 10K range
1% on the x1, x10, x 100 and x100K ranges
25dBc on the x1M range |
| Square Wave |
| Frequency Range |
0.004Hz to 4MHz |
| Rise/Fall Time |
< 50ns into 50W (High output terminals) |
| Symmetry |
±1% to 100KHz
±5% to 4MHz |
| Triangle |
| Linearity |
> 99% to 200KHz |
| Opearting Modes |
| Modes |
Operating modes (CW, Triggered, Gated, Sweep, Manually Triggered) |
| Trigger/Gate Input Level |
TTL |
| Trigger/Gate Frequency Range |
To 4MHz Max. |
| Trigger/Gate Minimum Pulse Width |
< 50ns |
| Sweep |
| Type |
Linear and Log |
| Sweep Time |
30ms to 60 seconds continuously variable |
| Sweep Width |
1:1,000 linear
1:10,000 log continuously variable
Sweep start and stop frequencies may be set with the Freq dial and the Freq. Stop control. |
| Outputs |
| Sync |
TTL level |
| GCV |
Output proportional to the selected frequency, 0 to -5V |
| Sweep |
4V P-P |
| Impedance |
600W |
| VCG Input |
| Input Voltage |
0 to ±4V P-P will cause a 1:1,000 frequency change (linear) and 1:10,000 (Log) |
| Input Impedance |
2KW |
| General Specifications |
| Operating Temperature |
0 to 50°C (32 to 120°F) |
| Size |
3.5" (H) x 11.4" (W) x 10.6" (D) |
| Weight |
5 lbs |
| AC Line Voltage |
120/220V, 50/60Hz |
| Accessories |
Manual, Line cord, BNC cable |
;)
