Click Image to Enlarge Protek 7700

Wide 10MHz to 1000MHz Frequency range Advanced DSP design converts any oscilloscope into a 1GHz spectrum analyzer. Requires minimum 20MHz Dual Trace Oscilloscope -90dBm sensitivity Resolution Bandwidths to 3kHz Direct CRT readout of frequency and signal level Can be used for EMI and RFI compliance testing This Spectrum Analyzer is ideal for testing AM, FM, CB, Cellular, Marine, Aircraft and Cable Televison equipment Troubleshoot IF and RF circuits, wireless products such as two way radios, PCS, and cellular telephones, cable TV systems, wireless remotes, microphones and monitors On-screen markers with freq and level readouts Internal Calibration signal

Download Data Sheet

Frequency

Range 10MHz to 1GHz, usable from 150kHz to 1.15GHz Resolution 1kHz center frequency Stability ± 10PPM Spans Zero span, 2kHz to 100MHz/Div in a 1-2-5 sequence Resolution Bandwidths 3kHz, 30kHz, 220kHz, 4MHz Resolution Bandwidth Accuracy ±15% Video Bandwidth 1.6kHz typical (auto switched with RBW) RF Sweep Rate 20mS/Div

Level Measurement

Input Level Range -100 dBm to +20dBm Usable Display Range 75dB Display Level Flatness ±1.5dB at less than 10MHz/Div. Display Range Linearity ±1.5dB over 70dB Range (Resolution Bandwidth dependant) Reference Level Range -30dBm to +20dBm Reference Level Accuracy ±1.5dB at 80MHz ±1.5dB over +20 to -30dBm setting Phase Noise -77dBc/Hz at 30kHz offset Average Noise -140dBm/Hz (typical)

RF Input

Impedance 50W Maximum Overload + 30 dBm for 1 minute max DC Block 50 Volts DC

General Specification

Power 11 V DC to 16V DC @ less than 1A Power Consumption Less than 1A Connectors RF Input: Type N; Video and trigger output: BNC Size 3.0" H x 8.5" W x 10.0" D Weight < 5 lbs. Supplied Accessories Manual, 12V @ 1 amp AC/DC Adapter