Vertical Amplifier
(CH 1 and CH 2) |
| Sensitivity |
5 mV/Div to 5V/Div in 10 steps (1,2, 5 sequence) |
| Accuracy |
±3% |
| Bandwidth (-3dB) |
(-3dB) DC: 0 to 2MHz
AC: 10Hz to 25MHz |
| Rise Time |
< 14ns |
| Input Impedance |
Resistance: 1MW ±5%
Capacitance: 25pF ±5pF |
| Input Coupling |
AC, DC, GND |
| Invert Channel |
CH2 |
| CH1/CH2 Trigger Output |
100mV/Div into 50W |
| Display Modes |
CH1, CH2, ALT, Chop, ADD, X-Y |
| Maximum Input Voltage |
400V Dc (Dc or Ac p-p) |
| Horizontal Sweep |
| Sweep Time |
200ns/Div to 0.5s/Div in 20 steps (1-2-5 seq)
(x10 Mag: 20nS/Div to 50mS/Div) |
| Accuracy |
±3% (± 5% X10 MAG) |
| Sweep Modes |
Normal, X-Y |
| Triggering |
| Source |
CH 1, CH 2, ALT, Line and EXT |
| Modes |
Auto, Norm, TV- V, TV-H, Trig lock |
| Slope |
Positive or Negative adjustable levels |
| Coupling |
AC |
| Sensitivity (Int) |
20Hz to 2 MHz: 0.5Div
2MHz to 25MHz: 1.5 Div |
| X-Y mode |
| TV |
INT: 1 Div.; EXT: 1V |
| ALT |
20Hz to 2MHz: 2.0Div
2MHz to 25MHz: 3.0 Div |
| EXT |
20Hz to 2MHz: 200mV
2MHz to 25MHz: 800mV |
| Inputs |
X- Axis: Ch1, Y-axis Ch2 |
| Sensitivity |
Same as CH 1 & CH2 |
| Accuracy |
± 4% |
| Frequency Response (-3dB) |
DC to ≥ 500KHZ |
| Phase difference |
< 3º from DC to 50KHz |
| Component Test |
| Test Voltage |
Approx. 4.5V rms open circuit |
| Test Current |
6.6mA Max short circuit |
| Test Frequency |
60Hz |
| Calibrator Signal |
| Waveform |
Square wave |
| Amplitude |
2V ± 2% p-p |
| Frequency |
1KHz ± 2% |
| CRT |
| Size |
8Cm x 10Cm |
| Acceleration Volts |
2KV |
| General Specifications |
| Power Requirements |
AC input Volts: 120V or 220V |
| Frequency |
50/60Hz |
| Power Consumption |
35W |
| Operating Temperature |
0 to 40ºC
(32º F to 104º F) |
| Dimensions |
12.5” (W) x 5.9 (H) x 18.0” (D) |
| Weight |
17 lbs |
| Accessories |
Manual, AC Line cord, (2) x1/x10 and Test cable |
| Ext.Trigger input |
| Impedance |
1MΩ ± 5% + 25pF Capacitance |
| Max. Input Volts |
400V (DC + AC peak) |
;)
