 |
 |
Fluke 789 ProcessMeter |
|
|
| |
|
|
| |
|
Fluke 789 ProcessMeter
Click image to enlarge
Fluke 789
Click here for pricing information
|
Loop Power Supply mA Source and Simulate
The Fluke 787 ProcessMeter was the first tool to combine a loop calibrator with a DMM to give process
technicians double the power in one tool. Now it's even better – the ultimate loop calibration multimeter – the Fluke 789 ProcessMeter. The 789 has a display
that's not only twice as large, but also twice as bright with two levels of backlighting. And with its built-in, selectable 250 ohm HART resistor, it eliminates the need to carry
a separate resistor with you. Now process technicians can do a lot more while carrying a lot less.
Online Virtual Demo
Increase the power of your Process Meter with FVF-SC2 FlukeView® Forms Documenting Software
|
Features at a Glance:
- DMM and Loop Calibrator in one tool
- DMM designed to meet 1000 volt IEC 1010 CAT III standards
- Precision 1000 V, 440 mA True-rms digital multimeter
- Frequency measurement to 20 kHz
- Min/Max/Average/Hold/Relative modes
- Diode Test and Continuity Beeper
- Simultaneous mA and % of scale readout
- 20 mA dc current source / loop calibrator / simulator
- Manual Step (100 %, 25 %, Coarse, Fine) plus Auto Step and Auto Ramp
- 24 V Loop power supply
- HART mode setting with loop power (adds 250 ohm resistor)
- 1200 ohm drive capability on mA source
- Enhanced backlight with two brightness settings
- 0-100% mA Span Check buttons to toggle between 4 and 20 mA
- Infrared I/O serial port compatible with FlukeView® Forms Software V 2.1 (available Feb. 2003)
- Externally accessible battery for easy battery changes
- Externally accessible fuses for easy replacement
Key New Features:
- 24 V Loop power supply
- HART mode setting with loop power (adds 250 ohm resistor)
- 100 % larger dual display
- 1,200 ohm drive capability on mA source
- Enhanced backlight with two brightness settings
- 0-100 % mA Span Check buttons to toggle between 4 and 20 mA
- Infrared I/O serial port compatible with FlukeView® Forms Software Version 2.1 (available Feb. 2003)
- Externally accessible fuses for easy replacement
- DMM designed to meet 1000 volt IEC 1010 CAT III standards
- Precision 1000 V, 440 mA true-rms digital multimeter
- Frequency measurement to 20 kHz
- Min/Max/Average/Hold/Relative modes
- Diode Test and Continuity Beeper
- Simultaneous mA and % of scale readout
- 20 mA dc current source / loop calibrator / simulator
- Manual Step (100 %, 25 %, Coarse, Fine) plus Auto Step and Auto Ramp
- Externally accessible battery for easy battery changes
|
|
|
| |
Tequipment.NET
205 Westwood Ave
Long Branch, NJ 07740
|
|
Tequipment.NET
Phone: 1-877-571-7901 / 732-222-7077
Fax: (732) 222-7088
E-mail: salesteam@Tequipment.NET
|
|
|
|
;)
