| Input Protection Limits |
| VAC |
600V DC/AC |
| V |
DC or V AC 600V DC/AC, 200Vrms on 200mV range |
| mA |
DC 200mA 250V fast acting fuse |
| A |
DC 20A 250V fast acting fuse(30 seconds max every 15 minutes) |
| Ohms, Continuity |
250Vrms for 15sec max |
| General |
| Diode Test |
Test current of 1mA maximum, open circuit voltage 2.8V DC typical |
| Continuity Check |
Audible signal will sound if the resistance is less than approximately 150 Ω |
| Input Impedance |
10M Ω |
| AC Response |
Average responding |
| ACV Bandwidth |
50Hz to 1kHz |
| DCA voltage drop |
200mV |
| Display |
3 1/2 digit, 2000 count LCD, 0.9 digits |
| Auto-Power Off |
15 minutes (approximately) |
| Overrange indication |
1 is displayed |
| Polarity |
Automatic (no indication for positive polarity), Minus (-) sign for negative polarity. |
| Measurement Rate |
2 times per second, nominal |
| Low Battery Indication |
is displayed if battery voltage drops below operating voltage |
| Battery |
One 9 volt (NEDA 1604) battery |
| Fuses |
mA, ľA ranges, 0.2A/250V fast blow A range, 20A/250V ceramic fast blow |
| Operating Temperature |
41°F to 104°F (5°C to 40°C) |
| Storage Temperature |
-4°F to 140°F (-20°C to 60°C) |
| Operating Humidity |
Max 80% up to 87vF (31°C) decreasing linearly to 50% at 104°F(40°C) |
| Storage Humidity |
<80% |
| Operating Altitude |
7000ft. (2000meters) maximum. |
| Weight |
0.753lb (342g) (includes holster). |
| Size |
7.36 x 3.2 x 2.0 (187 x 81 x 50mm) (includes holster) |
| Safety |
For indoor use and in accordance with the requirements for double insulation to IEC1010-1 (1995), EN61010-1 (1995) Overvoltage Category III, Pollution Degree 2. |
;)
