| Frequency Characteristics |
| Sine |
1μHz ~ 80MHz |
| Square |
1μHz ~ 40MHz |
| All Other waveforms |
1μHz ~ 100kHz |
| Frequency Stability |
±1x10-6 (22°C ±5°C) |
| Resolution |
1μHz |
| Accuracy |
≤ ± 5x10-6 (22°C ±5°C) |
| Data entry Units |
s, ms, Hz, kHz, MHz |
| Waveform Characteristics |
| Main Waveforms (Sine, Square) |
| Amplitude resolution |
12 bits |
| Sample Rate |
200MSa/s |
| Sine |
| Harmonic Distortion of Sine Wave* |
≤ - 50dBc (frequency ≤ 5MHz)
≤ - 45dBc (frequency ≤ 10MHz)
≤ - 40dBc (frequency ≤ 20MHz)
≤ - 35dBc (frequency ≤ 40MHz)
≤ - 30dBc (frequency > 40MHz) |
| THD* |
0.1% (20Hz ~ 100kHz) |
| Square |
| Rise and fall time* |
≤ 15ns |
| * = Note |
Test conditions for harmonic distortion, sine distortion, rise/fall time Output Amplitude 2Vp-p, Environmental temperature: 25°C±5°C |
| Arbitrary |
| Non volatile memory |
8 waveforms |
| Waveform length |
8~16000 points |
| Amplitude resolution |
10 bits |
| Frequency range |
1μHz~100kHz |
| Sample rate |
200MSa/s |
| Others built-in waveforms |
| 27 build-in standard and complex waveforms |
Sine, Square, Triangle, Positive Ramp, Falling Ramp, Noise, Pulse, Positive Pulse, Negative Pulse, Positive DC, Negative DC, Stair wave, Coded Pulse, Full wave rectified, Half-wave rectified, Sine transverse cut, Sine vertical cut, Sine phase modulation, Logarithmic, Exponential, Half-round, Sinx/x, Square root, Tangent, Cardiac, Earthquake, Combination |
| Waveform Length |
4096 dots |
| Amplitude Resolution |
10 bits |
| Pulse |
| Duty Cycle |
0.1% ~ 99.9% (below 10kHz)
1% ~ 99% (10kHz ~ 100kHz) |
| Rise/Fall Time |
≤ 100ns (Duty Cycle 20%) |
| DC signal characteristics |
| DC range |
≤ 10mV – 10V (high impedance) |
| DC Accuracy |
≤ ±5% of setting +10mV (high impedance) |
| Amplitude Characteristics |
| Amplitude Range |
Freq ≤ 40MHz: 2mV ~ 20Vpp (open circuit) , 1mV ~ 10Vpp (50Ω)
Freq > 40MHz: 2mV ~ 4Vp-p (open circuit), 1mV ~ 2Vpp (50Ω) |
| Resolution |
2μVpp (open circuit), 1μVpp (50Ω) |
| Accuracy |
± 1%+0.2mV (sine wave relative to 1kHz) |
| Stability |
±0.5 % /3 hours |
| Flatness |
| For amplitude |
≤ 2Vpp ±3% (freq≤ 5MHz), ±10% (5MHz
|
| For amplitude |
>2Vpp: ±5% (freq≤ 5MHz), ±10% (5MHz±20% (frequency>20MHz)
±1dBm (frequency>40MHz) |
| Output Impedance |
50Ω |
| Output Units |
Vpp, mVpp, Vrms, mVrms, dBm |
| DC Offset Characteristics |
| Offset Range (open circuit) |
Freq ≤ 40MHz): ±10Vpk ac+dc (Offset ≤ 2 x pk - pk amplitude)
Freq > 40MHz): ±2Vpk ac+dc (Offset ≤ 2 x pk - pk amplitude) |
| Offset Resolution 2μV (open circuit), 1μV (50Ω) |
| Offset Error |
±5% of setting +10mV (Ampl. ≤ 2Vpp into open circuit)
±5% of setting +20mV (Ampl. > 2Vpp into open circuit) |
| Modulation |
| AM Characteristics |
| Carrier Waveforms |
Sine or Square |
| Modulation Source |
Internal or external |
| Internal Modulating Waveform |
Sine, Square, Triangle, Rising/Falling Ramp |
| Frequency of modulating signal |
100μHz ~ 20kHz |
| Distortion |
≤ 2% |
| Modulation Depth |
1% ~ 120%, 1% ~ 80% (frequency>40MHz
Ampl > 2Vpp into open circuit) |
| Modulation Error |
± 5%+0.2% (100μHz < frequency ≤ 10kHz)
±10%+2% (10kHz < frequency ≤ 20kHz) |
| Max. Amplitude of ext. input signal |
3Vp-p (-1.5V~ +1.5V) |
| FM Characteristics |
| Carrier Waveforms |
Sine or Square |
| Modulation Source |
Internal or external |
| Internal Modulating Waveform |
Sine, Square, Triangle, Rising/Falling Ramp |
| Frequency of modulating signal |
100μHz ~ 10kHz |
| Deviation |
Max. 50% of carrier frequency for internal FM
Max 100kHz (carrier frequency≥ 5MHz) for external
FM, with input signal voltage 3Vp-p (-1.5V~+1.5V) |
| FSK Characteristics |
| Carrier Waveform |
Sine or Square |
| Control ModeI |
Internal or external trigger (external: TTL level, low level F1, high level F2) |
| FSK Rate |
0.1ms ~ 800s |
| PSK Characteristics |
| Carrier Waveform |
Sine or Square |
| PSK |
Phase 1 (P1) and Phase 2 (P2), range: 0.0 ~ 360.0° |
| Resolution |
0.1° |
| PSK rate |
0.1ms ~ 800s |
| Control Mode |
Internal or external trigger (external: TTL level, low level P1, high level P2) |
| Burst Characteristics |
| Waveform |
Sine or Square |
| Burst Counts |
1 ~ 10000 cycles |
| Time interval between bursts |
0.1ms ~ 800s |
| Control Mode |
Internal, single or external gated trigger |
| Frequency Sweep Characteristics |
| Waveform |
Sine or Square |
| Sweep Time |
1ms ~ 800s (linear), 100ms ~ 800s (log) |
| Sweep Mode |
Linear or Logarithmic |
| Start/ Stop Frequency |
Same as frequency range of Sine & Square |
| External trigger signal frequency |
DC ~ 1kHz (linear) DC~10Hz (log) |
| Control Mode |
Internal or external trigger |
| Inputs/ Outputs |
| Main Output |
| Impedance |
50Ω |
| Protection |
Short circuit and overload protected |
| Output MOD OUT |
| Frequency |
100Hz ~ 20kHz |
| Waveform |
Sine, Square, Triangle, Rising/Falling Ramp |
| Amplitude |
5Vp-p ± 5% |
| Output Impedance |
600Ω |
| Modulation IN |
3Vpp = 100% Modulation |
| External Input Trig/FSK/Burst |
Level - TTL |
| Universal Counter, Key Specs* |
| Frequency Range |
| Frequency Measurement |
1Hz ~ 100MHz |
| Totalize mode |
50MHz max |
| * For the full specification of the counter section refer to www.bkprecision.com |
| General |
| Power Supply |
198~242V or 99~121V, Frequency: 47~ 63Hz |
| Power Consumption |
<35VA |
| State Storage Memory |
| Storage Parameters |
frequency, amplitude, waveform, DC offset values, modulation parameters |
| Storage Capacity |
10 user configurable stored states |
| Dimensions (W x H x D) |
10” x 3.93” x 14.56” (255 mm x 100 mm x 370 mm) |
| Weight |
6.6lbs (3 kg) |
| Remote Interface |
RS232 |
| Safety designed according to |
EN61010 |
| EMC tested according to |
EN55022, EN55024, EN61326, EN601000 |
| Accessories |
| Included |
BNC to alligator cable, BNC to BNC cable, RS232 communication cable, power line cord, test report, spare fuse |
;)
