| Frequency section |
| Frequency range |
50kHz to 8.5GHz |
| Center frequency |
| Setting resolution |
100kHz
Allows rotary encoder, numeric key and function key |
| Accuracy |
within ±(30+20T)kHz±1dot T : Sweep time (s)
(frequency span : 200kHz to 10MHz, RBW : 30kHz, 23 ±5°C)
within ±(60+300T)kHz±1dot T : Sweep time (s)
(frequency span : 20MHz to 8.5GHz, RBW : 100kHz, 23 ±5°C) |
| RBW frequency error |
within ±6% of RBW (RBW : 3kHz, 30kHz)
within ±30% of RBW (RBW : 100kHz to 3MHz) |
| Frequency span |
| Setting range |
0Hz (zero span), 200kHz to 5GHz (1-2-5step) and 8.5GHz (full span) |
| Accuracy |
within ±3% ±20TkHz ±1dot (Frequency span : 200kHz to 10MHz, 23 ±5°C)
within ±3% ±200TkHz ±1dot (Frequency span : 20MHz to 8.5GHz, 23 ±5°C) T : Sweep time (s) |
| Display resolution |
Frequency span/250
Frequency span/1000 (only the measurement by RS-232C communication) |
| Display dot number |
251dots, 1001dots (only the measurement by RS-232C communication)
(The unit displays data in 251 horizontal dots, but it internally captures the trace in 1001 dots) |
| Resolution bandwidth |
3dB bandwidth |
| Setting range |
3kHz to 3MHz (1-3step) and AUTO |
| Accuracy |
within ±20% |
| Selectivity |
1 : 12 (typical, 3dB : 60dB) |
| Video bandwidth |
100Hz to 1MHz (1-3step), and AUTO |
| SSB Phase noise |
-90dBc / Hz (typical, 100kHz offset, RBW : 3kHz, VBW : 100Hz, Sweep time : 0.3s) |
| Spurious response |
less than -60dBc |
| Harmonics |
less than -40dBc (100MHz to 8.5GHz) |
| Amplitude section |
| Reference level |
| Setting range |
+10 to -60dBm (1dB step) |
| Accuracy |
within ±0.8dB ±1dot
(center frequency : 100MHz, RBW : 3MHz, VBW : OFF, ATT : 0dB, 23 ±5°C) |
| Unit |
dBm, dBV, dBmV, dBµV, dBµV/m, dBµA/m
(dBµV/m and dBµA/m is used the measuring function) |
| Average noise level |
-110dBm (typical, center frequency : 100MHz RBW : 3kHz, VBW : 100Hz) |
| Frequency Characteristic |
within ±2.0dB ±1dot (50kHz to100MHz)
within ±1.0dB ±1dot (100MHz to 8.5GHz) |
| Input impedance |
50ohm |
| Input VSWR |
less than 2.0 |
| Input attenuator |
| Operating range |
0 to 25dB (1dB step), coupled with reference level |
| Switching error |
within ±0.6dB |
| RBW switching error |
within ±0.6dB |
| Display resolution |
0.4dB (10dB/div), 0.08(2dB/div) |
| Display dot number |
200dot |
| Display scale |
| Scale |
10dB / div, 2dB / div |
| Accuracy |
within ±0.2dB / 2dB ±1dot
within ±0.8dB / 10dB ±1dot
within ±1.6dB / 70dB ±1dot |
| Input damage level |
+23dBm (CW average power), 25VDC |
| Input connector |
SMA (J) |
| Sweep section |
| Sweep time |
| Setting range |
10ms to 30s (1-3step, frequency span : 0 to 2GHz) and AUTO
30ms to 30s (1-3step, frequency span : 5GHz) and AUTO |
| Accuracy |
within ±0.1% ±1dot ( frequency span : 0 to 5GHz)
within ±2.5% ±1dot ( frequency span : full span) |
| Trigger mode |
AUTO (frequency span : zero span) |
| Detection mode |
Positive peak, Negative peak, Sample
(when sweep time is 10ms or 30ms, only Sample can be set) |
| Functions |
| Marker |
NORM : displays frequency (7 digits max) and level (4 digits max) at marker point.
DELTA : displays difference frequency and level between 2 markers |
| Peak search |
NORM : searches a peak point within 10div. Available NEXT peak (10max).
ZONE : searches a peak point within a zone designated by center and width. Marker moves to a peak point each sweep |
| Calculation |
NORM, MAX HOLD, MIN HOLD, AVERAGE, OVER WRITE
* MAX/MIN HOLD : 2 to 1024 times, AVERAGE : 2 to 256 |
| Measuring |
Channel power, Adjacent channel power, Occupied frequency bandwidth, Electric field strength (needs optional antenna), Magnetic field strength (needs optional magnetic field probe) measurement |
| AUTO tuning |
When pressing AUTO TUNE key, the maximum level spectrum within 3.3GHz bandwidth is adjusted to center, and reference level, RBW, VBW and sweep time are adjusted to optimum values |
| Save / Load |
| Save |
Saves 100 traces and 100 setups |
| Load |
Loads 1 trace and 1 setup |
| General |
| Communication |
| Interface |
RS-232C |
| Baud rate |
2,400 to 38,400bps |
| Hard copy |
Allows direct hard copy with an optional printer |
| Display |
| Display |
LCD |
| Backlight |
CFL backlight |
| Resolution |
320 (H) × 240 (V) dots |
| Power source |
| Battery |
Ni-MH Battery |
| External DC source |
Pin jack, DC5V / 4A |
| Other |
| Operating temperature |
0 to 40°C (Guaranteed at 23 ±10°C, without soft carrying case) |
| Operating humidity |
less than 40°C / 80%RH (Guaranteed at less than 33°C / 70%RH, without soft carrying case) |
| Storage temperature |
-20 to 60°C, less than 60°C / 70%RH |
| Dimensions |
162 (W) × 70 (H) × 260 (D) mm (exclude projections and stand) |
| Weight |
approx. 1.7kg (included battery), approx. 1.5kg(without battery) |
;)
